Chassis; Plug In Receiver Battery - Carson 1st Go-Kart RTR 50 010 3016 NEW GENERATION Betriebsanleitung

b. Chassis
Air filter
Starter
Frontrammer
c. Plug in Receiver Batteries
Insert 4 "AA" batteries into the receiver battery case as shown
(compare picture 1). Make sure positive (+) and negative (-)
ends are facing the correct direction. Then plug the pack into
the switch harness, inside the radio case. Black goes to black
and red goes to red. Replace the radio case cover.
Racer Tip:
Use rechargeable batteries! They last longer and are cheaper in
the long run. Replace the 4 "AA" car batteries with our NiMh
6 V/ 1100 mAh battery pack (50 060 8036 JR) (50 060 8037 BEC)
for longer life and economy.
Advice
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the toy
before being charged.
• Rechargeable batteries are only to be charged under adult
supervision.
Motor
Front axle
CARSON 1st Go-Kart RTR 50 010 3016
Gasservo
Front tyre
Picture 1
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the toy.
• The supply terminals are not to be short-circuited.
• Regular examination of transformer or battery charger for
any damage to their cord, plug, enclosure and other parts.
Muffler
Rear tyre
Receiver box
Fuel-tank
Steering servo
GB
7