Status Signals - Ottobock Genium-Bionic Prosthetic System 3B1 Gebrauchsanweisung

16.2.4 Status signals

Battery charger connected
LED on Status
power LED on
supply battery
charger
Battery charger disconnected
Beep Vibration
signal signal
1x short 1x short
3x short 3x short
Event
Power supply and battery charger operational. Battery charger not yet
connected to receiver.
Battery charger connected to receiver, good connection.
This display turns off automatically after approximately one minute to
avoid bothersome light at night. The charging process is not affected.
Event
Self-test completed successfully.
Product is operational.
Maintenance note:
e.g. service interval has been
exceeded, temporary disruption of a
sensor signal
Resolution
• Use the Cockpit app to check
the next maintenance date for
the prosthesis (see Page 88).
Should the date lie within the
next month, arrange a mainten­
ance appointment
O&P professional. For this
appointment, the O&P profes­
sional has to be provided with
the battery charger and power
supply in addition to the pros­
thesis with tube adapter.
• Conduct the self-test again by
connecting/disconnecting
battery charger.
• If the beep signal sounds again
and the maintenance date has
not yet been
exceeded, visit the O&P pro­
fessional soon. If necessary,
the prosthetist will forward the
prosthesis to an authorised
Ottobock Service Center.
• The product can be used
without restrictions. However,
vibration signals may not be
generated.
with the
the
reached or
103