Important; Basic Settings On The Transmitter - Carson DRAGSTER SPORT Betriebsanleitung

Important!!!

Before using your new DRAGSTER Brushless Controller for the first time
please note the following:
• Please read this manual carefully before using your new CARSON
DRAGSTER Brushless Controller!
• Always make sure that you have the right gear ratio. The vehicle must
not be geared low over a long period.
GB
• Only use original CARSON SHOOTER BL motors.
• Stop driving immediately if the cooling fan fails.
• Do not connect the battery cable (plus and minus) with reversed
polarity. The guarantee is not valid if a short circuit occurs.
• Select the correct battery type/under-voltage protection (Cut-Off).

1. Basic Settings on the Transmitter

To ensure that best operation of the electronic speed controller is not
compromised by default settings on the transmitter, certain settings on
the remote transmitter should be reset before programming the speed
controller.
• Set the upper end stop for the throttle/brake servo to maximum by
selecting the highest level for the upper EPA/ATV setting.
• Set the lower end stop for the throttle/brake servo to maximum as well
by selecting the highest level for the lower EPA/ATV setting.
• Set the trim of the throttle/brake lever to the middle position.
• Select the neutral position for the throttle/brake lever:
For training journey at e.g. 50/50 full throttle/braking
(with reverse travel)
For racing mode at e.g. 70/30 full throttle/braking
(without reverse travel)
26 CARSON DRAGSTER Brushless Controller