GB
The lid cannot be
opened after the
steam has been
fully released
A large amount of
steam is escaping
around the edge of
the outer body
Large amount of
steam is escaping
from safety valve
B3
The pressure
cooker is emitting
an unpleasant
odour
VI. ENVIRONMENTAL PROTECTION
Printed signs of materials used for manufacture, packing, components and accessories,
as well as their recycling, are on all the pieces if their dimensions enable it. The symbols on
the product or in the accompanying documentation mean that the used electric or electronic
products must not be disposed together with municipal wastes. Please, hand them over to
the collection points designed for their correct disposal, where they will be accepted free
of charge. By correct disposal of this product you can help to preserve valuable natural
resources and help to prevent possible negative impacts to the environment and to human
health, which could be the results of incorrect waste disposal. For further details ask the
municipal authorities or the nearest collecting point. Penalties can be charged for incorrect
disposal of such wastes, according to national regulations. If the appliance is to be put out of
operation definitely, we recommend cutting off the feeder cable, to disable its use.
Expert service must do the large maintenance or to intervene into inside parts of the
appliance! Non-observance of the instructions of the manufacturer cancels the right
for guarantee repair!
VII. TECHNICAL DATA
Voltage (~V/Hz)
Wattage (W)
Safety valve B3 is still in the up
position
Lid B is not properly closed
Gasket B6 is not in its place
There are food remains on the
gasket B6
Gasket B6 is worn out or
damaged
Lid B has been damaged (e.g. by
being dropped on the floor)
The grommet B4 is soiled (e.g.
food remains)
The grommet B4 is worn out or
damaged
The cooking pot C or the heating
plate A3 are soiled
Using a suitable tool
(e.g. skewer) push the safety
valve into the down position
Check the attachment of the lid
on the pressure cooker
Place the gasket in the correct
place in the lid
Remove the gasket from the lid
and clean it (see Maintenance)
Replace the damaged gasket
with a new one of the same type
(see Maintenance)
Contact the service department
Remove the grommet from the
valve and clean it
(see Maintenance)
Replace the damaged grommet
with a new one of the same type
(see Maintenance)
Check and if necessary clean the
contact surfaces of the cooking
pot and the heating plate
Shown on the type label of the appliance
Shown on the type label of the appliance
36
/ 71