Economy Operation; 10°C Heat Operation - Fujitsu AUYG12LVLB Bedienungsanleitung

ECONOMY OPERATION

Begin air conditioner operation before performing this procedure.
To Use the ECONOMY Operation
Press the ECONOMY button.
The ECONOMY indicator lamp (green) will light.
ECONOMY operation begins.
To Stop the ECONOMY Operation
Press the ECONOMY button again.
The ECONOMY indicator lamp (green) will go out.
Normal operation begins.
About ECONOMY Operation
At the maximum output, ECONOMY operation is approximately 70% of normal air conditioner operation for cooling and heating.
If the room is not cooled (or heated) well during ECONOMY operation, select normal operation.
●
During the monitor period in the AUTO mode, the air conditioner operation will not change to ECONOMY operation even if ECON-
●
OMY operation is selected by pressing the ECONOMY operation button.
When ECONOMY operation mode is operated, the room temperature will be little higher than the set-temp under cooling mode
●
and lower than set-temp under heating mode. Therefore, the ECONOMY mode is able to save more energy than other normal
mode.
In case of multi-type air conditioner, the ECONOMY operation mode is only available for the set indoor unit.
●
10°C HEAT OPERATION
Note: In simultaneous multi connection, this function by using the wireless remote controller cannot be used.
To use 10°C HEAT Operation
Press the 10°C HEAT button
The OPERATION indicator lamp (green) will go out, and the ECONOMY indicator lamp
(green) will light.
To stop 10°C HEAT Operation
Press the START/STOP button
Then the operation stops and the ECONOMY indicator lamp (green) will go out.
About the 10°C HEAT Operation
• The heating mode will not operate if the room temperature is high enough.
• The room temperature can be maintained at 10°C by pressing the 10°C HEAT button
so as to prevent the room temperature from falling too far.
• In case of multi-type air conditioner, if other indoor unit is used for heating, the temper-
ature of the room where the "10°C HEAT" function is applied will rise. When using the
"10°C HEAT" function, we recommend all indoor units should be run under the"10°C
HEAT" mode.
En-12
Indicator Lamp
:Lighting
While 10°C HEAT operation is in prog-
ress, only the following
operation can be used.
• SET
Indicator Lamp
:Lighting
:OFF
:OFF