Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Prior to first use of the remote control, you must assign the light to the remote control. Please perform the
following steps.
Assign the remote control:
1.
Turn on the light at the switch on the wall
2.
You have 2 seconds to press the "On" button ("I") on the desired shortcut key. Press this button until the light flashes.
Flashing indicates successful assignment of the light.
To assign several lights to one group, repeat the previous steps until you have assigned all of the lights.
Once you have assigned several lights to one group, these lights will always operate synchronously. The lights can no longer
be controlled individually (e.g. for dimming, changing colour, on/off).
Undo assignment / reset light:
1.
Disconnect the light from the power supply at the switch on the wall for approx. 10 seconds.
2.
Turn the light back on at the switch on the wall.
3.
Press the button of the linked group 5 times repeatedly.
4.
The light has successfully reset from the previous linked group.
The light can now be reassigned to a remote control or group by following the steps outlined above. To remove several lights
from a group, please repeat the previous steps for each light.
Master ON/OFF:
Pressing the Master ON/OFF button will either switch on or switch off all of the lights allocated to a remote control.
Simultaneous control of all lights assigned to a remote control:
If you want to simultaneously configure all lights assigned to a remote control (e.g. setting the colour), first switch off all of the
lights with the "Master OFF" button and then switch them back on with the "Master ON" button. All of the lights will now respond
to your input.
The lights can be controlled within a radius of up to 20m of the remote control. However, the range may be affected by walls or
other interference factors. If the range of the remote control decreases, please check the batteries (2x AAA, 1.5v) and replace
them if necessary.
Werbung
