Specifications; Ec Declaration Of Conformity - Makita HR2010 Bedienungsanleitung

ENGLISH
1-1. Switch trigger
2-1. Side grip
3-1. Bit shank
3-2. Bit grease
4-1. Bit
4-2. Chuck cover
5-1. Depth gauge

SPECIFICATIONS

Capacities
No load speed (min
Blows per minute
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
DOUBLE INSULATION
･
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an
recycling facility.
Intended use
The tool is intended for hammer drilling in brick, concrete
and stone.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
Explanation of general view
5-2. Clamp screw
5-3. Grip base
5-4. Side grip
6-1. Drill chuck
6-2. Chuck adapter
7-1. Commutator
7-2. Insulating tip
Model
Concrete
Steel
Wood
-1
)
Overall length
Net weight
Safety class
equipment and
environmentally compatible
END201-2
For European countries only
Noise and Vibration
The typical A-weighted sound pressure level is 85 dB (A).
Uncertainty is 3 dB(A).
The noise level under working may exceed 85 dB (A).
The typical weighted root mean square acceleration
value is 6 m/s
These values have been obtained according to
EN60745.
EC-DECLARATION OF CONFORMITY
Model; HR2010
its
We declare under our sole responsibility that this
product is in compliance with the following standards of
standardized documents;
EN60745, EN55014, EN61000 in accordance with
Council Directives, 2004/108/EC, 98/37/EC.
ENE041-1
000230
ENF002-1
Responsible Manufacturer:
Makita Corporation
3-11-8, Sumiyoshi-cho, Anjo, Aichi, JAPAN
Authorized Representative in Europe:
Makita International Europe Ltd.
Michigan Drive, Tongwell, Milton Keynes, Bucks MK15
8JD, ENGLAND
3
7-3. Carbon brush
8-1. Screwdriver
8-2. Brush holder cap
9-1. Lock nut wrench
9-2. Crank cap
10-1. Hammer grease
HR2010
20 mm
13 mm
24 mm
0 - 900
0 – 4 000
302 mm
3,2 kg
/II
Wear ear protection.
2
.
CE2007
Tomoyasu Kato
Director
ENG004-2
ENH101-8