Configuring The Device; Software Installation - LevelOne WAP-6201 Schnellinstallationsanleitung

Configuring the Device

To set up and manage the WAP-6201/ WAP-6202, you can use one of the following
methods:
1. Connect the access point and your computer to the same switch or router.
Manage the access point from the computer. (for FAT AP Mode)
2. Connect the access point to a WAC-1000/WAC-1001. Connect your computer to
the same network as that of the WAC-1000/WAC-1001. Manage the access
point from the computer via the WAC-1000/WAC-1001.(for FIT AP Mode)

Software Installation

To login to the LevelOne AP, please perform the following steps:
1. Check Your Network Settings to login web UI
Please make sure your PC can get IP address automatically, so the router can
communicate with your PC during configuration.
 Select "Control Panel" > "Network Connections".
 Right click the "Local Area Connection" and choose "Properties".
 Select the TCP/IP protocol for your network card.
 Click on the Properties button. You should then see the following screen and
make sure you have selected "Obtain IP address automatically"
6