Pairing The Headset With A Telephone (Hsp-Hfp) - GRAUPNER HoTT Bluetoothv3.0 + EDR Earphone Bedienungsanleitung

ble to make a connection within this time, it automatically switches to stand-by mode. To make a fresh
attempt, first switch the headset off, and then start again as described above.
• If you wish the headset to be paired automatically when the transmitter is switched on, select 'CONN.'
under "ID PAIR"; in this case the last successfully paired headset is connected automatically.
• In the "Volume" sub-menu you can adjust the headset's volume within the range 0 to 22 (default setting
8). However, it is also possible to alter the volume directly using the volume controls on the headset.
• The connection between the headset and the transmitter can be interrupted using any of the following
procedures:
• Switch the headset off: hold the headset button pressed in for about 3 - 5 seconds, and then release
it as soon as the Status LED lights up red; at the same time you will hear a long "DI" sound.
• Move to the "ID PAIR" sub-menu and briefly press the SET button. Use the arrow buttons  to
select 'OFF': this interrupts the connection between the headset and the transmitter.
• Move the headset out of range of the transmitter, i.e. about 10 m away.
• Erasing paired headsets: use the arrow buttons  of the left or right-hand touch-key to select the "BT
Headset" sub-menu, and briefly press the SET button. Select 'CLR' using the arrow buttons  of the
left or right-hand touch-key. Note: CLR erases all paired devices.
• Note: the headset's pairing mode continues for about two minutes. If it is unable to make a connection
within this time, it automatically switches to stand-by mode
5.3 Pairing the headset with a telephone (hsP - hFP)
• Ensure that the headset is switched off.
27
33002.23_de_en_fr_jhneu.indd 28
33002.23 Hott Bluetooth ® v3.0 + EDR Earphone
19.07.2013 12:29:45