Operation; Mounting / Removing The Grass Catcher; Level Gauge; Adjusting The Cut Height - Grizzly ERM 1434-3 Stow Originalbetriebsanleitung

Install curved handle:
3. Fasten the bow-type handle (1)
with the enclosed screws, wash-
ers and quick-release lever (3)
to the right and left of the lower
bar (4). Two positions are pos-
sible.
4. Clipping in the cable holders
Clip the cable holders (14) onto
the bar to fix the connection
cable (13) in position

Operation

Attention: Do not operate the ap-
pliance until the collision guard
and grass catcher are fully in-
stalled. Risk of injury!
Mounting / removing the grass
catcher
1. Lift the collision guard (5).
2. Place the grass catcher (7) on the
mounting bracket (18) provided at
the back of the lawn mower.
3. Lower the collision guard (5)
onto the grass catcher (7) - it
will keep it in place.
4. To remove the grass catcher (7),
lift the collision guard (5) and un-
hook the grass catcher from the
mounting bracket. Flap down the
collision guard to the housing.
On emptying the grass catcher
also refer to section "Disposal/
environment".

Level gauge

The level gauge (7a) is located on the
side of the grass catcher (7).
Flap open: grass catcher (7)
empty
Flap closed: grass catcher (7)
full

Adjusting the Cut Height

Switch off the equipment, discon-
nect the plug and wait for the blade
to stop. There is a risk of injury.
Hold the cutting height adjuster
(11) and move it to the correct cut-
ting height, as appropriate.
There are 6 different cutting heights:
25-75 mm
The correct height is around 30 – 45 mm
for a decorative lawn and around
30 –65 mm for a used lawn.
A higher cut height should be
selected for the first cut of the sea-
son.
A higher cut height should be se-
lected for the first cut of the season.

Switching On and Off

1. Plug the mains lead into the ap-
pliance's power inlet (16).
2. Turn the end of the mains lead
into a loop and hook it into the
cable strain relief (15).
3. Connect the equipment to the
power supply.
4. Before switching on, ensure that
the equipment is not in contact
with any objects.
5. To switch on, press the release
button (17) on the handle at the
GB
63