Electrical Connections - entrematic Ditec OBBI Serie Technisches Handbuch

7. Electrical connections

Before connecting the power supply, make sure the plate data correspond to that of the mains
power supply.
An omnipolar disconnection switch with minimum contact gaps of 3 mm must be included in the
mains supply.
Check that upstream of the electrical installation there is an adequate residual current circuit
breaker and a suitable overcurrent cutout.
The gearmotors OBB13BH-OBB13BFCH can be connected to the E2HOB control panel.
The electrical wiring and the start-up of the gearmotors OBBI3BH and OBBI3BFCH are shown in
figure and in the installation manuals of the E2H control panel.
E2HOB control panel terminal board
Motor 1
31
OBBI3BH Blue
OBBI3BFCH Brown
E2HOB control panel terminal board
Motor 2
34
OBBI3BH Black
OBBI3BFCH White
E2HOB control panel terminal board
Motor 1
31
OBBI3BH Black
OBBI3BFCH White
E2HOB control panel terminal board
Motor 2
34
OBBI3BH Blue
OBBI3BFCH Brown
35
32 33
/ Black
Green White
35 36
/ Blue
Green Brown
32 33
/ Blue
Green Brown
35 36
/ Black
Green White