Model Pas 151A | 181A - Omnitronic PAS Serie Bedienungsanleitung

Model PAS 151A | 181A

No. Function
1 Status indicators
POWER: speaker is powered on
SIGNAL: input signal is present
LIMIT: the signal level is too high; the limiter
will reduce the signal level to protect the
speakers. Reduce the volume with the master
control until the LED does not light anymore,
or only at signal peaks.
2 VOLUME control
For adjusting the overall volume.
3 INPUT jacks
Balanced XLR inputs for connecting audio
units with line level output (e.g. mixers or
preamplifiers).
4 Phase reversal switch
Allows switching the phase from 0° to 180°
when multiple speakers are operated in
parallel.
5 OUTPUT jacks
Balanced XLR jacks to connect another
subwoofer or active speaker system.
HIGH PASS/FULL RANGE output selector switch
6
Determine the signal at the resp. output.
• switch disengaged = Full-range operation
• switch engaged = 120 Hz high pass filter active
7 DSP PRESET switch
To select various equalizer presets: FLAT =
neutral frequency response, DJ = low bass
range boost, MONITOR = low bass range cut,
high bass range boost.
8 Fan
Do not cover to avoid overheating.
9 Power switch
Turns power to the speaker system on and off.
10 Power input with fuse holder
Used to plug in the supplied power cord. Only
replace the
disconnected from mains. Only use fuses of
the same rating and power. The correct fuse
value is specified on the rear panel.
20 • EN
fuse when the device is