Remote Control (Optional); Setting A Channel For Remote Control; Technical Data; Disposal - Bresser BR-24B Bedienungsanleitung

9 Remote control (optional)

The device can be controlled with a suitable 2.4GHz remote control* over the built-in receiver. When
using the same channel, different devices can be operated at the same time through the rermote con-
trol*.
To control the device through a remote control, proceed as follows:
1. Turn on the device(s).
2. Set the desired receiving channel to all lights being controlled.
3. Set the channel also for the remote control.
NOTICE! Only use the remote control recommended for this type of light! If a light is not to be
controlled synchronously, simply change the channel on the corresponding light.
*not included

10 Setting a channel for remote control

1. Press the djustment knob for approx. 2 seconds until two digits will flash in the display (currently
set channel).
2. Rotate adjustment knob to the right (+) to increase the value. Rotate the adjustment knob to the
left (-) to decrease the value.
3. Once the number on the display does not flash anymore the new channel value has been saved.

11 Technical data

Model
Power consumption
Number of LEDs
Luminous flux
Lamps
Color temperature
Dimmer
Operating voltage
Operating conditions
Storage conditions
Table 1: BR-24B
NOTICE! The LEDs used in this device have a very long lifespan and do not need to be changed.
The LEDs can not be changed due to technical reasons!

12 Disposal

Dispose of the packaging materials properly, according to their type, such as paper or card-
board. Contact your local waste-disposal service or environmental authority for information
on the proper disposal.
Do not dispose of electronic devices in the household garbage!
As per Directive 2012/19/EC of the European Parliament on waste electrical and electronic
equipment and its adaptation into German law, used electronic devices must be collected
separately and recycled in an environmentally friendly manner.
BR-24B (bicolor)
24W
240
2,400 LM
LED, not replaceable
3,200K to 5,600K
digital, 10% to 100%
DC 8.0V via power adapter
or optional
via lithium battery
1x NP-F750/NP-F960
dry, 0° C to +40° C
dry and dust-free, 0° C to +40° C
9 / 28