Clean The Everest Printer; Clean The Print Head - Rimage Everest III Benutzerhandbuch

Rimage Everest™ III and 600 User Guide
•
Everest III
For an Everest III, use the following
procedure.
a. With the supply roll on the left
side, unwind several inches of
the retransfer ribbon.
b. Slide the retransfer ribbon
under the retransfer ribbon
carrier.
c. Install the supply roll on the
left side of the retransfer ribbon
carrier. Be sure that the ribbon
goes over the supply roll.
d. Bring the take-up roll up and
around the guide rollers and
snap the roll into place.
3. Rotate the take-up roll counterclockwise
in order to tighten the retransfer ribbon.
4. Reassemble the printer.
a. Slide the retransfer carrier into the
printer.
b. Close latches 1, 2, and 3.
c. Close the side cover.
The printer is ready for use.

Clean the Everest Printer

Regular cleaning helps to keep your Everest printer in optimal operating condition.

Clean the Print Head

# Tools required:
•
Sponge swabs with long handles
(included in the Everest cleaning kit)
•
99% Isopropyl alcohol
1. Access the print head.
a. Press the two side cover latches to
release the side cover.
b. Lower the side cover.
c. Open latch 1.
d. Remove the print ribbon carrier.
For specific instructions, refer to the
Change the Print Ribbon
on page 25.
30
Supply Roll
procedure
Everest III
Latch 1
Take-up Roll
Retransfer
Ribbon
Carrier
Print Head
2000621_B