Touch Control; Start/Pause Button; Programme Selection - Hoover HNFTS S684TAH-01 Bedienungsanleitung

WARNING:
Don't touch the display (and the Touch
Control) while inserting the plug because
the machines calibrates the systems
during the first seconds: touching the
display, the machine couldn't work
property. In this case, remove the plug
and repeat the operation.

Touch Control

ON/OFF
"Press for at least 1 second the button of a
selected program
appliance (the display will light up, showing
the parameters of the selected cycle). To
switch off the appliance, press the OFF
for at least 3 seconds."

PROGRAMME SELECTION

To set a program press the related button
, the corresponding indicator will light up.
to turn on the
57
BUTTON SELECTION indicators
They light up at the touch of the related
button.
"X Red Light"
It lights up at the pressing of any button of
the Touch Control, with a diffused lighting
fading to the edges.
It gradually turns off within 5 minutes since
the last touch of a button, in order to save
energy.

START/PAUSE button

Close the door BEFORE selecting the
button START/PAUSE.
l
Press to start the selected cycle.
When the START/PAUSE button has
been pressed, the appliance can take
few seconds before it starts working.
ADD OR REMOVE ITEMS AFTER THE
PROGRAMMES HAS STARTED (PAUSE)
l
Press and hold the START/PAUSE
button for about 2 seconds (some
indicator light and the time remaining
indicator will flash, showing that the
machine has been paused).
l
Wait until the DOOR LOCKED light has
gone out before opening the door.
Before you open the door, please
check water level is below the door
opening to avoid flooding.
l
After you have added or removed items,
close the door
START/PAUSE button (the programme
will start from where it left off).
and press the