Inhaltsverzeichnis
Werbung
A part le remplacement des pile et fusibles, la réparation du multimètre doit
être effectuée par l'usine ou un Centre de Services agréé.
Le boîtier peut être nettoyé avec une savonnée douce. Laissez sécher
complètement avant utilisation.
Warning: To prevent electrical shock hazard, turn off the multimeter and any
device or circuit under test and disconnect the test leads before removing the
rear cover. Remove battery.
ΠFuse replacement: Unscrew the two screws and gently pry the rear
case away from the front case, releasing the two plastic hold down catch-
tabs. Replace blown fuse with equivalent. See table and figure 5 (one spare
0.5A/250V fuse is located on the right side of the battery compartment). The
fuses are fast-acting ceramic type.
Input
Fuse
10A
10A/600V
mA
0.5A/250V
CAP
0.1A/250V
Battery replacement: Remove battery and replace with NEDA type
1604 or equivalent 9-volt alkaline battery. Ž Replace rear case and secure
with screws.
Warning: Use only
an equivalent fuse
to the one specified.
Use of an incorrect
fuse could result in
serious injury or
even death.
BATTERY / FUSE REPLACEMENT
Size
(mm)
6.4x25.4
5x20
5x20
Hold Down
Catch-
– 29 –
Interrupt
Rating
6000A
1500A
200A
Fuses
Rear
Wavetek
Part Number*
FP400
FP225
FP125
* Pack of four
Battery
Front
Werbung
Inhaltsverzeichnis
