WHAT TO DO IF...
WARNING!
Before troubleshooting, disconnect
the mains plug from the mains
socket.
Only a qualified electrician or com-
petent person must do the trouble-
shooting that is not in this manual.
Problem
The appliance does
not operate. The
lamp does not oper-
ate.
The lamp does not
work.
The compressor op-
erates continually.
Water flows on the
rear plate of the re-
frigerator.
Water flows into the
refrigerator.
Possible cause
The appliance is switched
off.
The mains plug is not con-
nected to the mains socket
correctly.
The appliance has no pow-
er. There is no voltage in
the mains socket.
The lamp is in stand-by.
The lamp is defective.
The temperature is not set
correctly.
The door is not closed cor-
rectly.
The door has been opened
too frequently.
The product temperature is
too high.
The room temperature is
too high.
During the automatic de-
frosting process, frost de-
frosts on the rear plate.
The water outlet is clogged. Clean the water outlet.
Products prevent that wa-
ter flows into the water col-
lector.
There are some sounds during nor-
mal use (compressor, refrigerant
circulation).
Solution
Switch on the appliance.
Connect the mains plug to
the mains socket correctly.
Connect a different electrical
appliance to the mains sock-
et.
Contact a qualified electri-
cian.
Close and open the door.
Refer to "Replacing the
lamp".
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open
longer than necessary.
Let the product temperature
decrease to room tempera-
ture before storage.
Decrease the room temper-
ature.
This is correct.
Make sure that products do
not touch the rear plate.
ENGLISH
13