Care And Maintenance; Troubleshooting - LAVOR Pro METIS Bedienungsanleitung

3) Keep the trigger pressed
- If the display show H2O , it means that there is
no water in the tank. Fill the tank (see "Filling the
tanks with water")
> MACHINE STOP (AT END OF WORK)
At the end of the work shift, stop the machine in the
following way:
1) Press boiler switch button to (0) OFF ⑩
2) Press main switch to (0) OFF ⑨.
3) Unplug the machine from the electrical power
supply.
Boiler drain
Follow the instructions below:
- A few minutes before the end of the work shift,
turn off the boiler by pressing the BOILER START
luminous green push-button, continuing to use
the steam gun until the pressure gauge indicates
a value of 0-1 bar;
(see fig. E)
- Carefully open the boiler drain cock ⑯ , situated
on the machine and drain all the water from the
boiler into a suitable container;
WARNING: Danger from hot steam.
• WARNING:
• V15
While the machine is functioning, it
is strictly forbidden to remove safety devices
set by the Manufacturer for the purpose of
protecting the operator against incidents.
- Only skilled and qualified operators must use
the machine.
- Avoid aiming the steam lance towards
personnel or delicate objects such as plastic,
crystal or other materials which may melt or
deteriorate with contact to steam at 180°C.
- Never leave the machine unattended.
- Always remove the power supply from the
machine before filling the tanks.

CARE AND MAINTENANCE

IMPORTANT: Before doing any work
on the cleaner, discharge the pressure
and disconnect the electricity and water
supplies.
SEE ROUTINE MAINTENANCE TABLE
• WARNING
Before any maintenance or replacement activity,
remember to:
- stop the machine (MAIN SWITCH turned to
OFF)
- unplug it.
• K1 Maintenance, replacement or servicing
activities described in this handbook must be
entrusted only to skilled operators familiar
with the technology used on the machine.
• K2 Consult qualified personnel at the
manufacturer
adjustment, tuning or replacement actions not
included in this manual.
Machine general cleaning
Once a week, remove all the dust from the machine
using compressed air.
Clean the machine body externally with suitable de-
tergents.
• WARNING:
Always wear protective gloves when cleaning the
machine.

TROUBLESHOOTING

(see table)
• 22WARNING: To ensure machine safety, use
only original spare parts supplied or approved
by the manufacturer.
WARRANTY CONDITIONS
17
or sales outlet
EN
for any