How To Use; Operation; Assembling The Citrus Press; Extracting The Juice From Citrus Fruits - Silvercrest SZP 25 B2 Bedienungsanleitung

__RP270052_B3.book Seite 6 Freitag, 10. Juli 2015 12:46 12

5. How to use

• Remove all packing material.
• Check to ensure that all parts are pres-
ent and undamaged.
• Clean the device prior to its first
use (see "Cleaning" on page 7)!

6. Operation

6.1 Assembling the citrus
press
DANGER!
~ Only plug the mains plug|11 into the
wall socket after the device has been
completely assembled.
1. Uncoil the power cable|11 from the
cable wrap|10 to the desired length.
2. Place the base|9 on a dry, solid and
level surface.
3. Figure C: place the juice container|7
on the base|9 with the handle above
the arrow and turn it clockwise until it
locks into place.
4. Figure D: place the upper screen|4 on
the bottom screen|5 so that the screen
opener|6 sticks through the opening,
and the screens lock into place.
5. Place the assembled screen|4/5 on the
juice container|7 so that the handles fit
perfectly one on top of the other.
6. Place the small juicer cone|3 on the drive
axle|8. In the process, the small juicer
cone|3 must lock into the screen|4/5.
For large citrus fruits (e. g. oranges,
grapefruit) place the large juicer cone|2
on the small juicer cone|3 so that the
wings of the small juicer cone|3 fit into
the recesses of the large juicer cone|2.
7. Insert the mains plug|11 into a wall
socket corresponding to the technical
data.
6
GB
6.2 Extracting the juice from
citrus fruits
WARNING!
~ Ensure that no foreign body is on the
screen|4/5 or in the device when oper-
ating it.
~ Do not put excessive pressure on the
juicer cone|2/3.
NOTE:
• Empty the juice container|7 no later
than when filled to the 600 ml mark.
• In order to achieve the largest juice
yield possible, the juicer cone changes
the direction of rotation after several
starts and stops.
Setting the pulp content
Figure E: using the screen opener|6, you
can influence the pulp content of the juice:
• High pulp content: Set the screen opener|6
to the large dot marks so that the openings
in the screen|4/5 are open wide.
• Low pulp content: Set the screen open-
er|6 to the small dot marks so that the
openings in the screen|4/5 are closed.
1. Cut the citrus fruits in half.
2. Exert slight pressure on the halves of the
citrus fruit when pushing the cut surface
down onto the juicer cone|2/3. The
juicer cone|2/3 starts turning, and the
juice flows into the juice container|7.
3. As soon as you stop pressing on the
juicer cone|2/3, the device stops.
4. If the juicer cone|2/3 is not turning,
check if there are pips between the juic-
er cone and the screen|4/5 and re-
move them, if necessary.