Basic Connections - Sanyo VCC-HD2500P Bedienungsanleitung

Basic Connections

VCC-HD2500P
VCC-HD2500
Ⓐ 24 V AC
AC24V
24 V AC
AC24V
GND
Ⓑ 12 V DC
AC24V
12 V DC
AC24V
GND
①
Power Connection
Connect the power terminals (24 V AC/12 V DC) of the camera to a power supply.
Ⓐ Connection to 24 V AC power supply
Although the power terminals have no polarity, the earth grounding wire must be
connected to the GND (earth grounding) terminal.
Ⓑ Connection to 12 V DC power supply
Note the polarity (+/–) of the power terminals when connecting the camera to a
12 V DC power supply.
Incorrect polarity may cause damage to the camera.
•
Be sure to use an 18AWG or thicker wire power cable.
•
If you want to use PoE to supply power, do not connect to AC/DC power
supply.
②
Network Connection
This camera is designed so that you can use all of its functions via network
operation.
By connecting the network (LAN) socket of the camera to your PC using a LAN
cable, you can configure and operate it from the Web browser installed on your PC.
③
Camera Monitor Connection ("Lens Adjustment"
A monitor can be connected to perform focus adjustment with the camera.
Connect the monitor output socket (MONITOR OUT) of the camera to a monitor via
the monitor cable. After adjustment, be sure to remove the monitor cable.
POWER
CLASS2
WIRING
AUDIO
DC12V
AC24V
ALARM
AC24V
①
GND
1 2 COM 1 2
IN OUT
Power supply
VCC-HD2500P
②
LAN
VCC-HD2300P
VCC-HD2100P
③
5
PC
Monitor
Page 7)