Jacuzzi Start! 70 Installations Anweisung Bedienung Und Wartung Seite 17

Maintenance
A
CLEANING THE THERMOSTATIC VALVE
The thermostatic valve is provided with mesh filters to trap any
impurities in the water. Over time, these filters could become
clogged and, therefore, inhibit the functions of the mixer tap. To
clean them, do the following:
I Turn off the water supply (hot and cold) to the shower box.
I Drain the water from the mixing group by placing the devia-
tor ring nut (G) on the position "A - showerhead". Then set the
showerhead on the floor to improve water drainage. Complete-
ly open the stop tap (R), drain the remaining water, and then close
it again.
I (1) Remove the plug (T) from the knob of the mixer.
I (2-3-4) Remove the screw (V), slide off the knob (M) and
the cap of the mixer (C).
I (5) Unscrew the ring nut (H) that secures the thermostat-
ic valve.
I (6) Ease out the thermostatic valve (L) with the brass ring
and the cylinder.
Clean the mesh filters with a little brush and rinse. If scale is p-
resent, wash with specific products.
I (7) Reassemble the various components by following the
same procedure in reverse order. When installing the knob of
the thermostatic valve (M), use care in ascertaining its posi-
tion with respect to the graduated scale and the safety stop.
I (8) Fasten the thermostatic valve so that the screw peg (Q)
is facing downwards, and that it fits into the groove of the
brass component.
TAP FIXTURE, SHOWER PANEL
Just dry the various components after use. If you need to
clean them, simply remove any impurities with a soapy wet
cloth or neutral detergent, rinse with clean water and dry.
Do not use abrasive cloths, powder detergents, ace-
tone or other solvents.
SHOWER HEAD
FLEXIBLE SHOWERHEAD
These components are equipped with a scale-removal filter,
which can be cleaned with a sponge. For normal cleaning op-
erations, see instructions for taps.
17