Assembly And Adjustments; Tools; Scope Of Delivery; Assembly - Vermeiren 9300 Gebrauchsanweisung

5

Assembly and adjustments

The instructions in this chapter are for the user and the specialist dealer.
To find a service facility or specialist dealer near you, contact the nearest Vermeiren facility.
CAUTION
The wheelchair needs to be (dis)assembled and adjusted by a specialist dealer according to
the instructions in this chapter.
Only use parts and tools described in this manual.
While (dis)assembling and operating the wheelchair, make sure no objects or body parts get
caught between moving parts.
Make sure all screws are firmly secured before driving.
Important remarks
•
Be aware of the technical details and limits of intended use.
•
For more information, contact Vermeiren.
5.1

Tools

To (dis)assemble and adjust the comfort chair/wheelchair, the following tools are needed:
•
Wrench set no. 10
•
Allen keyset n° 4
5.2

Scope of delivery

The following items are part of the delivery:
•
Framework with seat, wheels, armrests and leg rests
•
Backrest
•
Tools
•
User manual
Before use, check if everything is included and that no products are damaged.
Please note that the basic configuration may differ in different European countries. Contact your
specialist dealer.
5.3

Assembly

The commode chair is delivered fully assembled, apart from the backrest. To install the backrest,
put in into place and tighten the bolts to fasten.
5.4

Adjustments

5.4.1 Seat width

1. Remove the seat by pulling it up and forwards from the
frame tubes.
2. Remove the backrest.
3. On one side of the frame, remove the 3 screw-bolt
connections (3) on the side of the seat frame tubes.
4. Slide the inner tubes inwards/outwards to the desired
position (5 possible positions).
5. Replace the screw-bolt connections (3) and tighten firmly.
6. Repeat the steps above for the other side of the frame.
7. Replace the seat and backrest.
Please note that there is a corresponding seat cushion and backrest for each seat width.
Risk of injuries or damage
9
9300, 9301, 9302, 9303
2019-11
Assembly and adjustments
3
EN
NL