Specifications - Panasonic BB-HCA11CE Installationsanleitung

7. Pass the necessary cables (AC adaptor, LAN,
etc.) through the whole in the dust protection
sheet, and attach the sheet to the bracket slits in
3 places.
• The size of each slit is different. Match the
size of the slits with the sheet notches, and
insert the sheet.
1
Dust Protection
Sheet
Notch
Slit
3
Cables
8. Secure the camera with the screw D (included
with the camera) in 3 places.
• Attach the camera so the " " mark on the unit
is aligned with the arrows on the bracket.
Screw D
9. 1 Attach the unit's cover by aligning the cover
and the microphone of the unit, and tighten
the screws in 3 places.
2 Close the screw covers.
(Recommended torque 0.2~0.4 N·m
{2.039~4.079 kgf·cm})
2
" " mark
arrow
Screw covers
10. Secure the ceiling mounting cover (included) to
the bracket.
1 Pass the safety wire through the ceiling
mounting cover as shown.
2 Align the " " marks on the rear of the camera
and on the mounting cover.
3 Turn the ceiling mounting cover clockwise
until the " " mark on the rear of the camera
and the " " mark on the ceiling mounting
cover are aligned as shown.
• Be careful not to nip the cables, cords, etc.
• To remove the ceiling mounting cover, turn it
counterclockwise until the " " mark on the rear
of the camera and on the ceiling mounting
cover are aligned, then lower the ceiling
mounting cover.
11. Secure the safety wire to the ceiling.
• Secure the bracket's safety wire first, using
screw A and the washer (included with the
bracket), then secure the camera's safety
wire, using screw A and washer A (both
included with the camera).
• Secure the safety wires to the ceiling about
160 mm from the center of the camera.
• Do not drive the screws into a soft material.
Drive the screws into a secure, 25 mm thick
area of the ceiling, such as a crossbeam,
otherwise the bracket and the camera may
fall. If there is no crossbeam, place a board on
the other side of the ceiling to make sure the
bracket and the camera are securely
mounted.
• Attach the safety wire in a position so that if
the camera were to become detached, it
would not fall on nearby people.
Washer
(Inside diameter:
4.0 mm)
Screw A
(Length: 20 mm,
Body diameter: 4.0)

Specifications

Operating +0 °C to +40 °C
temperature
Dimension About 204 mm × 77.5 mm × 204 mm
(W×H×D)
Weight About 635 g
Washer A
(Inside diameter: 4.0 mm)
Screw A
(Length: 20 mm,
Body diameter: 4.0 mm)
5