Temperature Control And Adjustment; Before Operating - Beko FSA25300 Bedienungsanleitung

GB
4. The appliance should be positioned on a
smooth surface. The two front feet can be
adjusted as required.To ensure that your
appliance is standing upright adjust the two
front feet by turning clockwise or anti-
clockwise, until firm contact is secured with
the floor. Correct adjustment of feet prevents
excessive vibration and noise (Item 4).
5. Refer to "Cleaning and Care" section to
prepare your appliance for use.

Temperature control and adjustment

The freezer temperature is influenced by the
thermostat button position.
Generally, this temperature is between -18° C
and -28° C during all working cycle.
We recommend checking the temperature
with a thermometer to ensure that the storage
compartments are kept to the desired
temperature. Remember to take the reading
immediately since the thermometer
temperature will rise very rapidly after you
remove it from the freezer.
Please remember that each time the door is
opened cold air escapes and the internal
temperature rises. Therefore never leave the
door open and ensure it is closed immediately
after food is put in or removed.

Before operating

Final Check
Before you start using the freezer check that:
1. The feet have been adjusted for perfect
levelling.
2. The interior is dry and air can circulate
freely at the rear.
3. The interior is clean as recommended
under "CLEANING AND CARE."
4. The plug is inserted into the wall socket and
the electricity supply is switched on. Avoid
accidental disconnection by taping over the
switch. Green and red lights will glow and the
compressor will start running when the freezer
is first time put in to functioning.
And note that:
5. You will hear a noise as the compressor
starts up. The liquid and gases sealed within
the refrigeration system may also make some
noise, whether the compressor is running or
not. This is quite normal.
6. To freeze the fresh foods use the
compartment marked with 4 stars (fast- freeze
compartment).
7. Don't put in freezer a too big quantity of
foods in the same time. The foods quality is
well kept if they are deeply frozen in the
shortest time possible. Therefore it is
preferable do not exceed the freezing capacity
of the appliance shown in "Appliance record".
The thermostat shall be adjusted in order to
obtain the lowest temperature inside the
freezer with the fast freeze button and the
yellow lamp lighting.
8. After the time necessary to freeze the
fresh foods from the freezer is finished, set
the thermostat button on a medium position
(yellow lamp is not lighting).
9. Do not load the appliance immediately it is
switched on. Wait until the correct storage
temperature has been reached. We
recommend that you check the temperature
with an accurate thermometer (see;
Temperature Control and Adjustment).
Important Note:
If there is a power failure do not open the
door. Frozen food should not be affected if the
failure lasts for less than 19 hours. If the
failure is longer, then the food should be
checked and either eaten immediately or
cooked and then re-frozen.
3
Instruction for use