Releasing The Pressure - Parker ServiceJunior Bedienungsanleitung

5.3 Releasing the Pressure

After completing the pressure measurement, the excess pressure must be released from
the test kit.
CAUTION!
Risk of injury through escaping hydraulic fluid.
► Never disassemble components connected to the test kit when it is pres-
surised!
► Open the pressure release valve before disassembling components!
In the case of large-volume measuring set-ups or hydraulic fluid has been refilled
after venting the test object, hydraulic fluid can escape at the safety valve.
► Pay attention to the test kit when releasing the pressure!
► Release the pressure carefully!
► Pay attention to the fill level in the supply tank!
► Collect any hydraulic fluid which escapes and dispose of it according to
the applicable laws!
1 Hold the test kit so that no hydraulic fluid is at the cap of the supply tank.
2 Turn the pressure release valve 2 revolutions counterclockwise and wait until the
measuring set-up is depressurised.
3 The components can be disassembled from the test kit.
V1.0/08/13
Operating the Test Kit
19