Inhaltsverzeichnis
Werbung
Note ambient
temperature and
ventilation
The climatic class can be found on the
rating plate and specifies the ambient
temperatures at which the appliance may
be operated. The rating plate is situated in
the bottom left hand side of the
appliance.
Climatic class
SN
N
ST
T
Ventilation
The air at the back of the appliance will
heat up. This warm air must be allowed to
freely escape, otherwise the refrigerating
machine must perform more. This raises
electricity consumption. Hence, the
air inlet and outlet apertures should never
be covered or blocked off!
Permitted ambient
temperature
+10 °C to 32 °C
+16 °C to 32 °C
+18 °C to 38 °C
+18 °C to 43 °C
Installing the appliance
Install the appliance in a dry, well
ventilated room. The installation location
should neither be exposed to direct
sunlight nor near a heat source, e.g.
a cooker, radiator, etc. If installation next
to a heat source is unavoidable, use
a suitable insulating plate or observe the
following minimum distances to a heat
source:
3 cm to an electric cooker.
30 cm to an oil or solid fuel cooker.
Connecting the
appliance
After installing the appliance, wait at least
½ hour before switching on the appliance.
During transportation the oil in the
compressor may have flowed into the
refrigeration system.
Before switching on the appliance for the
first time, clean the interior (see Cleaning).
The socket should be freely accessible.
Connect the appliance to
220-240 V/50 Hz alternating current via
a correctly installed earthed socket.
The socket must be fused with
a 10 A to 16 A fuse or higher.
en
23
Werbung
Inhaltsverzeichnis
