Removing The Shelf Holders; Electrical Connection; Ventilation Requirements; Installation Of The Carbon Air Filter - AEG SANTO Z 9 18 40-5i Benutzerhandbuch

Removing the shelf holders

Your appliance is equipped with shelf retainers
that make it possible to secure the shelves during
transportation.
To remove them proceed as follows:
1. Move the shelf holders in the direction of the
arrow (A).
2. Raise the shelf from the rear and push it for-
ward until it is freed (B).
3. Remove the retainers (C).

Electrical connection

Before plugging in, ensure that the voltage and frequency shown on the rating plate corre-
spond to your domestic power supply.
The appliance must be earthed. The power supply cable plug is provided with a contact for
this purpose. If the domestic power supply socket is not earthed, connect the appliance to a
separate earth in compliance with current regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if the above safety precautions are not ob-
served.
This appliance complies with the E.E.C. Directives.

Ventilation requirements

The airflow behind the appliance must be suffi-
cient.

Installation of the carbon air filter

The carbon air filter is an active carbon filter which absorbs bad odours and permits to
maintain the best flavour and aroma for all foodstuffs without risk of odour cross contami-
nation.
Installation
A
B
C
min.
50 mm
200 cm
2
41
min.
200 cm
2