CHIEF iC Serie Installationsanleitung Seite 14

iCSPDA2
3B
75 x 75mm, 100 x 100mm
7
100 x 200mm, 200 x 200mm
14
A
5
(J, K) x4
2
(N, P) x4
1
A
5
L x2
F x2
2
(N, P) x4
Recessed Mounting Holes
IMPORTANT!
4mm diameter mounting holes are recessed into back
surface of display.
WARNING:
result in serious personal injury or damage to
equipment! It is the installer's responsibility to make
sure the combined weight of all components
attached to the iCSPDA2 does not exceed 40 lbs
(18 kg).
1. Carefully place display face down on protective
surface.
2. Place four spacers (N or P, as applicable) over
each mounting hole on back of display. Select
shortest spacer which will provide adequate fill.
All spacers must be same length.
NOTE:
100 x 100 and 200 x 200 mounting hole
patterns shown; 75 x 75mm and 100 x 200mm
patterns similar.
3. Select screw length:
• If using spacers (N), then use screws (J).
• If using spacers (P), then use screws (K).
NOTE:
If installing screws (J, K) through brackets (F),
then also use washers (L) for lower pair of
teardrop mounting holes.
4. Orient arm assembly (A) so that teardrop mounting
holes are aligned with holes in spacers (N or P, as
applicable).
(J, K) x4
CAUTION:
damage your display! Proper screws will easily and
completely thread into display mounting holes.
5. Install screws (J or K, as applicable) through
washers (L, if applicable), teardrop mounting holes,
and spacers (N or P, as applicable), into display.
Tighten all four screws. Do not overtighten!
6. Continue with "INSTALL ARM ASSEMBLY TO
WALL PLATE."
1
Installation Instructions
This procedure only applicable when
Exceeding the weight capacity can
Using screws of improper size may