Care And Maintenance; How To Dismantle Parts - Atag KA2011LP Gebrauchsanweisung

How to dismantle parts

Freezer
Separate the lamp by pulling it out (➂) while
compartment slightly striking (➀) and rotating (➁) the lamp
cover.
lamp
Turn the bulb counterclockwise. Max. 40 W bulb
for refrigerator is used and can be purchased at
a service center.
Dispenser lamp
Separate the lamp by pulling it out, and then
remove the lamp. Max. 15 W bulb for
refrigerator is used and can be purchased at a
service center.
Freezer
To remove a shelf, lift the left part of the shelf
compartment
a bit, push it to the direction ( ), lift the right
shelf part to the direction ( ), and take it out.
Door rack and
Lift the door rack holding both sides ( ) and
support pull it out to ( ) direction.
Space plus Lift the space plus ( ) and pull it out to ( )
direction.
Ice storage bin
Hold the ice storage bin as shown in the right
figure and pull it out ( ) while slightly lifting it
( ).
The water collector has no self-drainage
After dispenser
function. So it should be cleaned regularly.
is used
Remove the cover by pulling the front of the
water collector cover and dry it with a cloth.
46
NOTE
Dismantling is done in the reverse sequence of assembly.
•
Be sure to unplug the power plug before dismantling and assembly.
Never apply severe force to dismantle parts. Parts may be damaged.
It is recommended not to dismantle the ice
storage bin unless it is necessary.
Be sure to use both hands when removing
the ice storage bin, so as not to drop it on the
floor.
If the ice storage bin does not fit well, slightly
rotate the rotating device.

Care and maintenance

!