Quick Setup (Path: Menu/Quick Setup) - Mettler Toledo M300 FLOW Schnellinstallationsanleitung

5 Quick Setup
Quick Setup allows limited configuration of the most common functions of the M300 Flow transmitter.
Detailed information for each function can be found in the individual sections of the manual.
Enter Quick Setup mode
GPM
75.5
L/min
283.9
MENU
Quick Setup
Flow Sensor Type Selection
GPM
75.5
L/min
283.9
ì
Sensor Type Input High
Measurement Selection
GPM
75.5
L/min
283.9
a GPM
ì
Analog Output? Yes
GPM
75.5
0.000 Gals
10
(PATH: Menu/Quick Setup)
While in Measurement mode press
Setup» and press the [ENTER] key.
Note: To exit Quick Setup mode at any time press the
ly (Escape). The transmitter returns to the Measurement mode and the old values
remain active.
Refer to Section 4 for Flow sensor type information.
Select the desired flow sensor type which corresponds to the type of flow sensor wired
to the transmitter. The choices are High, Low and Type 2.
Select the desired line (a or c) to configure the values to be displayed and whether this
value will have an Analog Output.
Convention:
1st line on display = > a
3rd line on display = > c
Example:
– By selecting a and GPM as units, the flow rate value will be displayed on the 1st line.
– By selecting c and Gals as units, the total flow value will be displayed on the 3rd line
of the display which has more digits of resolution.
– Selecting None means the display will be blank for the line selected.
to bring up the Menu selection. Select «Quick
and keys simultaneous-