What To Do If - Zanussi ZQF11430DA Benutzerhandbuch

4. leave the door/doors open to prevent unpleasant
smells.

What to do if...

Warning! Before troubleshooting, disconnect the
mains plug from the mains socket.
Only a qualified electrician or competent person must do
the troubleshooting that is not in this manual.
Problem
The appliance does not operate.
The Pilot light does not flash.
The Pilot light flashes.
The Alarm light flashes.
The acoustic alarm sounds
The compressor operates contin-
ually.
The temperature in the freezer is
too low.
The temperature in the freezer is
too high.
16
Possible cause
The appliance is switched off.
The mains plug is not connected to the
mains socket correctly.
The appliance has no power. There is
no voltage in the mains socket.
The appliance is not working properly.
The temperature in the freezer is too
high.
The temperature in the freezer is too
high.
The temperature is not set correctly.
The door is not closed correctly.
The door has been opened too fre-
quently.
The product temperature is too high.
The room temperature is too high.
The Fast Freeze function is switched
on.
The temperature regulator is not set
correctly.
The Fast Freeze function is switched
on.
The temperature regulator is not set
correctly.
The door is not closed correctly.
Important! If the cabinet will be kept on, ask somebody to
check it once in a while to prevent the food inside from
spoiling in case of a power failure.
Important! There are some sounds during normal use
(compressor, refrigerant circulation).
Switch on the appliance.
Connect the mains plug to the mains
socket correctly.
Connect a different electrical appliance
to the mains socket.
Contact a qualified electrician.
Contact a qualified electrician.
Refer to "Excessive Temperature Alarm"
Refer to "Excessive Temperature Alarm"
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open longer than
necessary.
Let the product temperature decrease to
room temperature before storage.
Decrease the room temperature.
Refer to "Fast Freeze function".
Set a higher temperature.
Refer to" Fast Freeze function".
Set a lower temperature.
Refer to "Closing the door".
Solution