Setting Speaker Levels; Select [Initialize] Under [Level] In [Speaker]; Setting The Sa-Cd Configuration - Yamaha DVD-S1800 Bedienungsanleitung

Initialize
You can reset [Distance] settings to the initial factory
settings.
1
Select [Initialize] under [Distance] in
[SPEAKER] menu.
2
Press .
The confirmation screen appears.
3
Select [Yes] to reset the setting, and then press
ENTER.
[Distance] settings are reset to the initial factory
settings.

Setting speaker levels

You can set the volume levels for individual speakers.
• Select [Level] in [SPEAKER] menu.
Front L, Center, Front R, Surround L, Surround R,
Subwoofer
Set the volume levels for front L/R speakers, center
speaker, surround L/R speakers or subwoofer.
Control range: 0dB to –12dB
Control step: 1dB
Test Tone
A test tone can be output to help you judge the volume
level of each speaker.
1
Select [Test Tone] under [Level] in [SPEAKER]
menu.
2
Press to select [Off], [Manual] or [Auto].
/
Off
Select this to output no test tone.
Manual
Select this to output the test tone manually.
Auto
Select this to output the test tone from each speaker
automatically.
3
For [Auto], press
/
press ENTER to output the test tone. For
[Manual], press
ENTER
and then press
Notes
• The test tone is not output from a center speaker, surround
speakers, and a subwoofer when the [Analog Output] setting is
set to [Stereo] (see "Setting the analog output" on page 31).
• These settings are only effective for analog output.
to select [Yes] and then
/ to select each speaker,
to output the test tone.
Initialize
You can reset [Level] settings to the initial factory settings.
1

Select [Initialize] under [Level] in [SPEAKER]

menu.
2
Press .
The confirmation screen appears.
3
Select [Yes] to reset the setting, and then press
ENTER.
[Level] settings are reset to the initial factory
settings.

Setting the SA-CD configuration

You can select speaker sizes and on/off statuses for
SA-CD discs. You can also select a cut-off (cross-over)
frequency for all low-frequency signals. All frequencies
below the selected frequency are sent to the subwoofer.
• Select [SA-CD] in [SPEAKER] menu.
SA-CD Config
Select speaker sizes and on/off statuses from the following
three settings.
Speaker
Config 1
Front L/R Large
Center Large
Surround L/R Large
Subwoofer On
CUT-OFF Frequency
Select a cut-off (cross-over) frequency for all low-
frequency signals. All frequencies below the selected
frequency are sent to the subwoofer.
Control range: 60, 80, 100, 120 (Hz)
SETUP MENU
Size or on/off
Config 2 Config 3
Small Large
Small Small
Small Small
On Off
33
En