Troubleshooting - Amprobe LT-10 Bedienungsanleitung

TROUBLESHOOTING

Lamp tester doesn't work:
Problem: Possible low or dead battery
Action: Check and/or replace battery
Low lamp tester response:
Problem:
1. Possible low battery
2. Bad contact between the probe/antenna and the lamp tester
Action:
1. Check and/or replace battery
2. Test the area on the lamp where the probe/antenna can make good
contact against lamp glass surface or the lamp socket
Antenna doesn't work:
Problem:
1. Possible low battery
2. Bad contact between the antenna and the lamp under test
3. Bad connection contact between the probe and antenna
Action:
1. Check and/or replace battery
2. Test the area on the lamp where the antenna can make good contact
against lamp glass surface or the lamp socket
3. Check and re-install the antenna. Make sure the antenna is securely
locked onto the probe. If the antenna is still not working, the
antenna may be damaged. Contact a service center for repair or
antenna replacement
Sodium lamp antenna doesn't work:
Problem:
1. Possible low battery
2. Bad contact between the probe and the lamp socket
NOTE: The insulated probe may not work on socket of energy saving
lamp.
Action:
1. Check and/or replace battery
2. Test the glass tube on the lamp with the probe.
16