Opex OMATION Envelopene 410 Serie Bedienungsanleitung Seite 100

3. The depth of the cutter can be fine adjusted by turning the cutter depth
screw (Figure 4-20). Using a Phillips screwdriver, turn the screw in 1/4-turn
increments, to the right for a deeper cut, or to the left for a shallower cut.
4. Replace the cover and run an envelope through to verify if it has been cut
now.
5. If envelopes are not being cut, repeat steps 1 through 4 as needed.
Increments smaller than 1/4 turn can be used to fine tune the cutter.
50
OMATION® Series 410 Envelopener™ Operator Manual
Turn right in 1/4 turn
increments for a deeper cut
Figure 4-20: Adjusting the cutter depth
OPEX Corporation
Operation