Herunterladen Inhalt Inhalt Diese Seite drucken

Astralpool JELLY - RGB Colours Installations- Und Bedienungsanleitungen Seite 7

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 44
S I G N A T U R E
With each stroke, you can make a change in colour or sequence. The colour and sequence
cycle is rotational. If for example, you have colour 5, you would obtain colour 6 with the following
stroke; if you hit it again, you would obtain sequence 1. If you are in sequence 7, you would
obtain colour 2 in the following stroke which corresponds to Red.
Colour 1 corresponds to white and is obtained by a long stroke.
COLOrPLus TOP: CONTrOL THrOuGH MODuLATOr AND/Or rEMOTE CONTrOL
The system features 20 operational modes: 12 fixed colours and 8 different colour sequences.
Turning the lamps on and off, colour and sequence changes and a shut-off time are controlled
by the Modulator.
If you have a remote control, besides receiver-modulator functions, the remote control will allow
you to activate and deactivate the presence of the colours that make up a sequence and select
the shut-off time.
Electrical connection diagram
For proper installation, you need the Modulator, the transformer and the LED lamp. Optionally,
this system can be controlled by Remote Control.
The Modulator connects to the 230 Vac electrical
mains through the two terminals we indicate as RED
and connects to the transformer primary (230 Vac)
through the terminals indicated with TRF (see attached
diagram).
The transformer must be large enough to supply 60VA
per led lamp that is connected to it. For example, if
you wish to control 5 lamps, you must connect them in
parallel to a 300VA transformer minimum.
Each Modulator can control up to a maximum of 15 LEDs.
Diagram for Jelly Projectors with Mini and Micro projectors.
Feeder
Synchronization Cable
7

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Jelly - white

Inhaltsverzeichnis