Anomaly Codes; Packaging, Transport; Storage; Disposal Of The Product - bürkert SE56 Bedienungs- Und Installationsanleitung

CODES ANOMALIE DESCRIPTIONS
0001 problem with watch-dog circuit
0002 wrong configuration work data in eeprom
0004 wrong configuration safety data in eeprom
0008 defective eeprom
defective keyboard (one or more key are pushed
0010
during the test)
0020 Power supply voltage (+3.3) is out of range
0040 Power supply voltage (+13) is too low (<10V)
0080 Power supply voltage (+13) is too high (>14V)
0200 timeout calibration input (input circuit is broken)
0400 Input stage gaining is out of range
0800 Interruption on the coils circuit
0C00 Cumulative alarm 0800 + 0400

PACKAGING, TRANSPORT

ATTENTION
Damage due to transport
- Transport may damage an insufficiently protected device.
- Transport the device in shock-resistant packaging and away from humidity and
dirt.
- Do not expose the device to temperatures that may exceed the admissible
storage temperature range.
- Protect the electrical interfaces using protective plugs.

STORAGE

CAUTION
Poor storage can damage the device.
- Store the device in a dry place away from dust.
- Storage temperature: XX to XX °C.

DISPOSAL OF THE PRODUCT

Dispose of the device and its packaging in an environmentally friendly way.
CAUTION
Damage to the environment caused by products contaminated by fluids.
Keep to the existing provisions on the subject of waste disposal and
environmental protection.
Note:
Comply with the national and/or local regulations which concern the area of waste disposal.

ANOMALY CODES

Check the status of the cables connecting the sensor to the
transmitter, the grounding connections or the possible presence of
strong and anomalous noise sources
Check the status of the cables connecting
transmitter
see single code
31
ACTION TO TAKE
ADDRESS TO SERVICE
the sensor to the
SE 56