SELFSAT SNIPE DISH Serie Benutzeranleitung Seite 28

20
Get controller cable and signal cables, cable holder and gland for installation
21
Put the cable inside the cable holder as above picture
22
Place the assemble cable holder inside the tape
markings. Drill three(3) 2mm holes
24
Apply silicone around cable holder and on the
top of the screws for waterproof
23
Fix cable holder on the vehicle roof with
three(3) of M4 x 20 screws at drill holes made
25
Connect cables to fassigned and remove
masking tape then tidy silicone before dry
ENGLISH - 27