Description Of The Appliance; Maintenance; Environmental Protection - eta Rosalia Bedienungsanleitung

II. DESCRIPTION OF THE APPLIANCE
A – hair straightener
A1 – ON/OFF switch
A2 – light operating signalization
A3 – heating plates
III. INSTRUCTIONS FOR USE
Remove all packing material, take out the appliance. Remove all possible adhesion foils,
stick-on labels or paper from the appliance.
ON/OFF switch
Switch on the hair straightener by pressing A1 button to ON position. Control light A2
will turn red. As soon as the operating temperature is set (max. 220 °C), it will be kept
automatically. Switch off the appliance after use by pushing A1 button to OFF position
(control light A2 will go out).
Hair straightening
Use the hair straightener for washed and dried or slightly damp hair, never for wet hair.
Before using the hair straightener, comb the hair so that it is not disheveled. Start with
styling the lower hair first. When styling hair, do not put locks of hair that are too thick
between the plates. Divide a lock in about 5 cm of its width and put it into an open hair
straightener. Then close the hair straightener by pushing and move it slowly on the lock
from roots towards hair tips. You can curl the tips thanks to round edges of the plates
upwards or downwards. Repeat the process till you have created the required hairstyle.
Let the hair cool down before the final styling.
Lock
The lock is used for safe and effective storing of the straightener in the closed position.
IV. MAINTENANCE
Allow the appliance to cool down before any maintenance! Do not use rough and
aggressive detergents! Treat the surface with a wet and soft cloth. Put the cooled
straightener to a safe and dry place, out of reach of children and incapacitated persons.
More extensive maintenance or maintenance requiring intervention in the inner parts
of the appliance must be carried out by a professional service! Failure to comply with
the instructions of the manufacturer will lead to expiration of the right to guarantee repair!
V. ENVIRONMENTAL PROTECTION
If the dimensions allow, there are labels of materials used for production of packing,
components and accessories as well as their recycling on all parts. The symbols specified
on the product or in the accompanying documentation mean that the used electrical or
electronic products must not be disposed of together with municipal waste. For proper
disposal, hand them over at special collection places where they will be accepted free of
charge. Suitable disposal of the product can help to maintain valuable natural resources
and to prevent possible negative impacts on the environment and human health, which
could be the possible consequences of improper waste disposal. Ask for more details at
the local authority or at the local waste collection site.
A4 – straightener´s end
A5 – turning joint of power cord
A6 – power cord
A7 – slider control of jaw lock
13 / 27
GB