Eton TRAVELER II DIGITAL G8 Benutzerhandbuch Seite 6

Traveler II Digital G8 OWNER'S MANUAL
VOLUME
Use the volume knob, on the right side, to adjust the volume.
LISTENING TO FM, AM, LW (Longwave) or SW
Select the FM, AM, LW or SW band by pressing the FM, AM/LW, or \/ SW /\
buttons . AM is shown as MW (medium wave). Use the TUNING knob to tune
the radio to the desired frequency, or press \/ /\ buttons to search for the next
available station. Each station will play for 5s before searching for the next
available station. Press any key to stay on your favor station.
If you are using an earphone to listen to FM-stereo, the FM-stereo symbol
will appear under FM on the left side of the display. This only appears when
earphones are plugged in.
NOTE: Longwave is not used for broadcasting in the United States and Canada.
It is used in the United Kingdom and in Europe. If you hear stations in the Long-
wave band, they may be 'images' of AM stations.
LISTENING TO SHORTWAVE
Each short press of the \/ SW /\ buttons takes the radio into a different shortwave
meter band (frequency range). The band number appears briefly in the upper
right corner of the display. After you're in a band, use the TUNING knob to tune,
or press and hold the \/ SW /\ buttons for 2 seconds to tune or to engage the 5
second scan. To stop the 5 second scan, press on any buttons again or slightly
rotate the tuning knob. Notice that when you use the \/ SW /\ buttons to scan,
the radio scans in 5 KHz steps. This is OK, because shortwave broadcast stations
are exactly 5 KHz apart. The tuning knob tunes in 1 KHz steps. While using these
buttons the band number appears in the display.
6