Setting Up Your Itower; Setting Up Clock; Charging Your Iphone/Ipod; Sleep Mode - THOMSON DS401 Bedienungsanleitung

Setting up Your Tower
Carefully take the tower body and base out of the packaging. Stand the tower upright on the
floor. The appliance is now ready for use.
Power
Place the unit in the desired position and unravel the mains cable. Insert the cable into the
supply socket and switch on if applicable.
Setting Clock
After the unit is plugged into a mains supply or mains power failure, the
display will show the "0:00" on the LCD display. The unit should be in
standby mode to set the current clock.
1. Press MEM/TIME button, the digits for the display will blink.
2 .Press the PREVIOUS/NEXT button repeatedly until correct hour is set. Press the MEM/TIME
to confirm.
The hour setting; the minute digits on the display will blink.
3. Press the PREVIOUS/NEXT button repeatedly until correct minute is set. Press the
MEM/TIME to confirm the minute setting.
Setting Alarm
Press and hold MEM/TIME button in shutdown state, the display will flash ON/OFF to select
setting alarm or canceling alarm.
Press PREVIOUS/NEXT to select ON, and the display will blink.
Press PREVIOUS/NEXT button repeatedly to set hour. Press MEM/TIME to confirm, then press
PREVIOUS/NEXT to set minute.
Press MEM/TIME to confirm, and then press PREVIOUS/NEXT to select iPod/Aux in status.
Press MEM/TIME to confirm.
When no iPod is connected, the unit will change to Aux in alarm automatically.
The volume would turn up from 0 to 25 gradually.

Sleep Mode

Press the SLEEP button, the display will blink. Press the button until the display shows the
minute you want to set. You can set 10 to 90 minutes.
It blinks three times to confirm, and then return to the interface before. If you want to cancel the
sleep mode, press to 00, after blanking three times, the sleep mode will cancel.

Charging your iPhone/iPod

You can charge your iPhone/iPod via the dock in either stand by or
operation mode.
Your iPhone/iPod will automatically charging when it is docked.
Please ensure that the main power switch at the rear of the unit is in the on position.
- 4 -