Herunterladen Inhalt Inhalt Diese Seite drucken

Troubleshooting And Corrective Action; Disposal Of Cleaning / Servicing Substances; Specification Data - WALTHER PILOT PILOT Misch-Automatik Betriebsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

For the PILOT Misch-Automatik WALTHER has a repair set with all wearing parts
available :
Parts No.:
V 16 243 40 000
Wearing parts are also shown in the listing of replacement parts (in bold face).
8

Troubleshooting and Corrective Action

Warning
Prior to any servicing and repair work: Make sure that the spray gun is in unpressu-
rized condition, i.e. all air and material inputs must be shut off - if not, imminent risk
of injury.
Fault
Cause
Gun is dripping
Material nozzle or needle
fouled
Material nozzle or needle
damaged
Needle gland nut too
tight
Gun fails to open
Control air pressure too
low
Spray jet pulsating or
Level in material tank too
unsteady
low
9

Disposal of Cleaning / Servicing Substances

Disposal of any such substances must be in accordance with all applicable local and
national regulations, directives and laws.
Warning
Pay special attention to all processing specifications and safety warnings issued by
the manufacturers of spraying and cleaning media. The improper disposal of any
toxic waste material represents a serious threat to the environment, i.e. to the health
of mankind and animal life.
Remedy
see 5.5 Retooling the Spray
Gun and cleaning
see 7.2 Replacing Material
Control Nozzle or Needle
Loosen needle gland nut
(Item 15) in slightly with a
screw driver
Increaese control air pressu-
re to at least 4.5 bar
Top-up material level (see
operating instructions of plant
systems manufacturer)
34
10

Specification Data

Weight::
795 g
Nozzle Sizes:
▪ 0,5 ▪ 0,8 ▪ 1,0 ▪ 1,2 ▪ 1,5 ▪ 1,8 ▪ 2,0
▪ 2,2 ▪ 2,5 mm ø (further sizes on request)
Connections:
Atomizing Air
G 1/4"
Control Air
G 1/4"
Material Inlet
Hose grommet 8 mm inside
Material Inlet:
Hose grommet 9 mm inside
Pressure Ranges:
Control Air
mind. 4,5 bar
Material pressure
max. 8
Atomizing Air
max. 8
max. Operating Temperature
of Spray gun
80 °C
Sound Level
(measured at a distance
of 1 m from the spray gun)
86 dB (A)
in litres/min.:
Air Consumption
Air input of the Air consumption
spray gun
1,0 bar
2,0 bar
3,0 bar
4,0 bar
5,0 bar
6,0 bar
Right to effect technical changes reserved.
35
bar
bar
Round fan
Wide fan
230
280
290
390
340
450
390
510
430
550
470
600

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis