Putting The Machine In Operation; Trimming Grass And Weeds; Adjusting Nylon Line - Mogatec FlexoTrim 1522 AA Gebrauchsanweisung

5

Putting the machine in operation

6
Adjusting the additional handle, the angle of in-
clination and the tube length
7
1
8
2
9
3
GB | Operating Instructions
Pull the radius guide (Fig. 5)
X
apart somewhat and insert it in
the openings on either side pro-
vided for the purpose.
• Insert the charged battery into
the trimmer. The locking latch at
the battery must properly lock in
place.
• Take a safe standing position.
Hold the mowing machine with
both hands. Do not put the mow-
ing head on the ground.
• Press switch to start the machine.
Release the switch to stop the
machine.
1. Adjust the front handle: Loosen
the star bolt (Fig. 7) and adjust
the handle to the desired position.
Tighten the star bolt..
2. Adjust the length of the shaft:
(Fig. 8) Loosen the threaded
sleeve (2) by turning it clockwise.
Slide the shaft in/out to the de-
sired length. Tighten the threaded
sleeve (2) by turning it counter-
clockwise.
3. Adjusting the angle of inclina-
tion (Fig. 9): Pull the button (3)
upwards. Select one of 3 possible
angles of inclination for the motor
element. Let go of the button 3 to
lock the motor element in its position.
The middle position is suitable
to reach under objects as, e.g.,
bushes or garden furniture with the
trimmer.
The lower position is used for trim-
ming edges as described in the
following section.
10

Trimming grass and weeds

11

Adjusting nylon line

Check the nylon line regularly if it is damaged or if it still has the correct
length.
12
13
14
X
GB-5
4. Adjusting the tool for trimming
edges (Fig. 10): Slide the shaft
to its shortest or longest position
as explained under No. 2. In this
position, the whole upper part of
the handle can be turned by 180°.
Also in connection with this activi-
ty, the tube length can be adjusted
to any positions.
• Sweep trimmer back and forth
uniformly to cut small patches of
grass or weeds. The trimmer is
not constructed and suitable for
cutting large areas.
• Wherever possible, cut with left-
hand side so that cuttings, dust
and stones are thrown forwards,
away from the user.
• Ideal working conditions
achieved if the trimmer is tilted to
the left at an angle approx. of 30°.
When cutting performance dete-
riorates: Hold the running trimmer
above a patch of grass. Tap the
cutting head on the ground. Note
the fresh line will be advanced only
if lines are still at least 2.5 cm (1
inch) long.
If the line(s) is (are) shorter: Switch
off the trimmer, disconnect plug from
power supply. Press in the spool
and pull end of line(s) firmly out-
wards. If end of line(s) is (are) not
visible - see (replacement of spool).
Your trimmer has a thread cut-
ting blade that continuously cuts
the thread down to the appropriate
length (fig. 14).
Note: Clean the thread cutting blade
from grass remainders in order to
guarantee an unaffected cutting per-
formance.
Attention: Danger of injury through
the cutting blade!
are