Herunterladen Inhalt Inhalt Diese Seite drucken

tau K996M Installationsanleitung Seite 18

Vorschau ausblenden Andere Handbücher für K996M:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 22
n°4
ON:
(no reverse) during opening the overhead door ignores any closing commands.
OFF: the overhead door's behavior depends on the position of dip switch No.2. The
direction can be reversed also during the opening manoeuvre.
n°5
ON:
resistive sensitive edge connected. Connect the resistive sensitive edge, with the
related 8,2 KΩ resistance, to terminals 11-12.
OFF: sensitive edge (fixed edge) connected. Connect the fixed edge to terminals 11-12.
If no sensitive edge is used, short circuit terminals 11-12.
n°6
ON:
the memorization function is enabled for self-learning of the travel.
OFF: leave the dip-switch in this position when the memorization procedure has been
completed.
IMPORTANT:
Each pair of terminals attached to an NC contact that is not in use must be
short-circuited in order to ensure the proper operation of the board.
The door's earthing system must comply with current standards. The manu-
facturer will accept no liability for any damage deriving from failure to comply
with this requirement.
433.92 MHz BUILT-IN RADIO RECEIVER
The radio receiver can learn up to a maximum of 8 dip-switches (TXD2, TXD4, BUG2, BUG4)
or rolling codes (BUG2R, BUG4R).
The learning mode (dip-switch or rolling code) is determined by the first radio control device and
remains unchanged until all the codes have been cancelled.
LEARNING SYSTEM FOR RADIO CONTROL DEVICES
P-RX = OPEN/CLOSE
1_ press button P-RX briefly to associate a radio control device with the OPEN/CLOSE function;
2_ LED DL4 turns off to indicate that the code learning mode has been activated;
3_ press the button of the relative radio control device;
4_ LED DL4 turns on again to indicate that the code has been memorised (if this does not hap-
pen, wait 10 seconds and start again from point 1);
5_ to memorise codes to other radio control devices, repeat the procedure from point 1 up to a
maximum of 8 transmitters;
6_ to exit the learning mode without memorising a code, press button P-RX briefly.
If the maximum number of codes (8) is exceeded, LED DL4 flashes rapidly
without memorising the code.
CANCELLING CODES FROM RADIO CONTROL DEVICES
1_ keep button P-RX pressed for 3 seconds in order to cancel all the associated radio control
devices;
2_ LED DL4 flashes slowly to indicate that the cancellation mode has been activated;
3_ press button P-RX again for 3 seconds;
4_ LED DL4 turns off for approx. 3 seconds and then remains steady to indicate that the code
has been cancelled;
5_ to exit the learning mode without cancelling a code, press button P-RX briefly.
WARNING: If you wish to memorize a new type of remote control (e.g.: from
dip-switches to rolling code or vice-versa) it is necessary to carry out a delete
procedure.
18
K996M

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis