Winstalling The Pan-Tilt Head - Panasonic AW-PH400E Bedienungsanleitung

Indoor Pan/Tilt Head AW-PH400
Installation
w Installing the pan-tilt head
When installing the pan-tilt head, check the "Pan-tilt head mounting conditions" on the previous page, and be sure to follow the
instructions below.
In order to prevent accidents caused by the pan-tilt head dropping out or falling off, be absolutely sure to install a drop prevention
underneath support plate separately from the pan-tilt head.
Do not install the unit on its side because it will not be able to operate or perform as originally designed.
p The installation surface must have a strength at least 5 times greater than the specified withdrawal strength per anchor
used.
p After fashioning the anchors or hangers, install the pan-tilt head, and take measures to prevent it from dropping.
p After the pan-tilt head has been installed, mount the camera onto the pan-tilt head.
p Embed the anchors to the depth recommended by the manufacturer of the anchors.
p Use M6 bolts or nuts for the pan-tilt head mounting holes (4 locations) to install the pan-tilt head.
p Use the M8 bolt or nut for the underneath support plate hole (1 location) to install the underneath support plate.
p When mounting onto anchors with external threads, check that the anchor bolts protrude at least 7 mm from the nuts used
to mount the pan-tilt head and underneath support plate. (Fig. 1)
p When mounting onto anchors with internal threads, check that the bolts engage with the female anchors to a depth at least
two times the bolt diameter. (Fig. 2)
p Be absolutely sure to use the flat washers and spring washers for the hexagon head bolts and nuts.
Recommended tightening torque:
For tightening, use a torque wrench with which the torque can be specified.
p Avoid installation on plaster board or wooden surfaces since these surfaces are not strong enough.
p Install the units in such a way that the devices mounted on the pan-tilt head and their cables will not touch any surrounding
objects when the pan-tilt head is rotated.
p When the pan-tilt head is not going to be used any longer, do not leave it in place but be absolutely sure to dispose of it.
p Tighten up the screws and bolts using the specified torque. If they are tightened using too much torque, the thread ridges
will be damaged, and the pan-tilt head may fall. Conversely, if they are tightened using too little torque, the screws may
come loose.
p Use a torque driver or torque wrench in order to tighten the parts at the specified torque.
p There are limits on the torque range that can be specified by torque drivers and torque wrenches. Use the specified torque
values that are recommended as a reference, and use the appropriate torque driver or torque wrench.
p Do not use impact drivers or electrical drivers whose torque is difficult to control since doing so may damage the screws
and bolts.
(Be sure to ask your dealer to install the unit.)
Bolts
Hexagon head bolts (M6)
Hexagon head bolt (M8)
Clamping torque
5.0 N m (50 kgf cm)
• •
12.0 N m (120 kgf
• •
17 (E)
cm)