Note is valid for Turkey only: The lifetime of our products is ten (10) years
Service Parts
Indoor air filter
1.
2.
3.
Indoor unit
1.
2.
• Avoid direct contact of any coil treatment cleaners on plastic part. This may cause plastic part to deform as a result
of chemical reaction.
1.
Open the front panel.
•
Hold the panel at the recesses on the main unit
(2 recesses on right and left sides) and lift it until it
stops.
2.
Remove the front panel.
•
While lifting the front panel further, slide it to the right
and pull it to the front side. The left rotating shaft is
detached. Slide the right rotating shaft to the left and
pull it to the front side to remove it.
3.
Attach the front panel.
•
Align the right and left rotating shafts of the front panel
with the grooves and push them all the way in.
•
Gently close the front panel. (Push both ends and the
center on the front panel.)
SERVICE AND MAINTENANCE
Maintenance Procedures
Remove any dust adhering to the filter by using a vacuum cleaner or
wash in lukewarm water (below 40°C/104°F) with a neutral cleaning
detergent.
Rinse the filter well and dry before placing it back onto the unit.
Do not use gasoline, volatile substances or chemicals to clean the
filter.
Clean any dirt or dust on the grille or panel by wiping it with a soft
cloth soaked in lukewarm water (below 40°C/104°F) and a neutral
detergent solution.
Do not use gasoline, volatile substances or chemicals to clean the
indoor unit.
! CAUTION
Rotating
shaft
1-14
Period
At least once every
2 weeks.
More frequently if
necessary.
At least once every
2 weeks.
More frequently if
necessary.
Recess on
main unit