Safety Notices For Chargers; Operation; Charging The Battery Pack; Inserting / Removing The Battery Pack Into / Out Of The Drill / Grinder - Parkside PFBS 10.8 A1 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

A void abrading paints containing lead or other
substances hazardous to health.
D o not machine materials containing asbestos.
Asbestos is a known carcinogen.
A void contact with moving sanding or grinding
tools.
D o not machine moist materials or damp surfaces.
NOTE! Do not allow the tool to come to a stand-
still by overloading it!
the device off and allow it to come to a standstill
before you put it down.
dry and free of oil or grease.

Safety notices for chargers

This appliance can be used by children aged from
8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of
experience and knowledge if they have been giv-
en supervision or instruction concerning use of the
appliance in a safe way and understand the
hazards involved. Children shall not play with
the appliance. Cleaning and user maintenance
shall not be made by children without supervision.
The charger is only suitable for
indoor use.
If the mains power cable of this appliance is
damaged, it has to be replaced by the manu-
facturer or its service department or a similarly
qualified person in order to avoid hazards.

Operation

Q
Never use the device for a purpose for which it was
not intended or with non-original parts / accessories.
The use of tools or accessories other than those rec-
ommended in the operating instructions could lead
to you suffering an injury.
General safety advice for electrical power tools / Operation
RISK OF INJURY! Switch
Always keep the device clean,

Charging the battery pack

Q
NOTE! A battery pack that has been unused for a
while or never been charged must be charged before
reuse or first use. The battery pack requires about
3–5 cycles before it can reach its full charge. The
charging process takes about 180 minutes.
CAUTION! RISK OF INJURY! Always pull
out the mains plug (mains adapter
you insert the battery pack into or take it out of
the charger.
I nsert the battery pack
cradle . This can only be inserted with the
9
correct polarity.
C onnect the adapter
The red charge level indicator
long as the battery pack is being charged. Once
charging is completed the red charge level in-
dicator will extinguish and the green charge
11
level indicator
11 a
pack is ready for use.
4
CAUTION! Do not charge a battery pack for
a second time in close succession. There is a
danger of overcharging the battery pack.
Inserting / removing the
Q
battery pack into / out of
the drill / grinder
Inserting the battery pack:
S et the ON / OFF switch
I nsert the battery pack
until it engages.
Removing the battery pack:
P ressing the battery pack buttons
sides at the same time allows you to remove
the battery pack
4

Reading off the battery status

Q
The status or residual power is indicated as follows
in the battery-operated LED
ance is switched on:
RED / ORANGE / GREEN = maximum charge / power
) before
10
into the charging
4
to a mains socket.
10
will light up as
11
will light up. The battery
to position "0".
5
into the drill / grinder
4
at the
3
.
whenever the appli-
2
GB 13