Safe Use; Modifications And Alterations - Stahl 8070/2 Serie Betriebsanleitung

Safety Notes
EN
3.3

Safe Use

EN
Before mounting
EN
• Read and observe the safety notes in these operating instructions!
• Ensure that the contents of these operating instructions are fully understood by the
EN
personnel in charge.
EN
• Use the device in accordance with its intended and approved purpose only.
EN
• Always consult with R. STAHL Schaltgeräte GmbH if using the device under operating
conditions which are not covered by the technical data.
EN
• Make sure that the device is not damaged.
EN
• We cannot be held liable for damage at the device caused by incorrect or unauthorised
EN
use or non-compliance with these operating instructions.
EN
For mounting and installation
EN
• Have mounting and installation performed only by qualified and authorised persons
EN
(see chapter "Qualification of the personnel").
EN
• The device is only to be installed in areas for which it is suited based on its marking.
• During installation and operation, observe the information (characteristic values and
EN
rated operating conditions) on the rating, data and information plates located on the
EN
device.
EN
• Before installation, make sure that the device is not damaged.
EN
Commissioning, maintenance, repair
EN
• Only have commissioning and repairs performed by qualified and authorised persons
EN
(see chapter "Personnel qualification").
• Before commissioning, make sure that the device is not damaged.
EN
• Perform only maintenance work described in these operating instructions.
EN
• The device must not be operated if there are dust deposits that are 50 mm thick,
EN
as stated in IEC/EN 61241-0.
EN
3.4

Modifications and Alterations

EN
EN
6
Position Switches
Series 8070/2
Explosion hazard due to modifications and alterations to the device!
Non-compliance results in severe or fatal injuries.
• Do not modify or alter the device.
No liability or warranty for damage resulting from modifications and
alterations.
DANGER
262223 / 8070613300
2019-11-21·BA00·III·en·03