Philips HR1890 Benutzerhandbuch Seite 10

ENGLISH
12
Troubleshooting
This chapter summarises the most common problems you could encounter with the
appliance. If you are unable to solve the problem with the information below, visit
www.philips.com/support for a list of frequently asked questions or contact the
Consumer Care Centre in your country.
Problem
The appliance does not
work.
The motor unit gives off
an unpleasant smell
the first few times the
appliance is used.
The juicing unit cannot
be placed onto the
motor unit.
The juicing unit is
blocked.
Solution
The appliance is equipped with two safety pins. If either
the juicing unit or the pulp container has not been
placed on the motor unit properly, the appliance does
not work. Check whether these parts have been
assembled in the right way (see chapter 'Preparing for
use').
This is not unusual. If the appliance continues to give off
this smell after a few times, check the quantities you are
processing and the processing time.
Check if the spout is properly attached to the juicing
unit. Make sure that the projections on the juicing unit
are aligned with the recesses in the motor unit (see
fig. 9).
Press the pre-clean button for a few seconds. If the
juicing unit is still blocked, then switch off the appliance,
remove the juicing unit and disassemble all parts.
Remove the fruit that is blocking the juicing unit. Then
process a smaller quantity.