Petsafe Aqua Fountain MWW19-15767 Anleitung Seite 9

PET FOUNTAIN: Clean the Pet Fountain once a week.
1. Unplug the Pet Fountain and disconnect
the In-Line Plug (Fig. 6).
2. Remove the Housing Lid and remove
the Charcoal Filter.
3. Empty the water out of the Pet Fountain.
4. Flip the Bowl over and slide the Rubber
Gasket off of the Bowl. Remove the cord
from the Cord Channel, it should now be
loose for easy removal (Fig. 7).
5. Remove the Housing by squeezing the
Bowl just beneath the locking tabs at the
back and lift up on the Housing (Fig. 8).
Cord Channel
Rubber Gasket
Fig. 7
6. Remove the Foam Filter from the underside of the Housing (Fig. 9).
7. Remove the Pump from its cavity by placing your index finger and thumb on each
side and lift the Pump straight up – this may require slight force until suction cups
release (Fig. 10).
Fig. 9
8. Pull the electrical power cord up through the opening until the Pump is completely
removed from the Bowl.
Foam Filter
www.aquapetfountain.com
Fig. 6
Fig. 8
Fig. 10
9