Zanussi zba 6160 a Gebrauchsanweisung Seite 43

4. From the plastic cover (E), which is used to cover the
hinge with the pivot pin, you must take away the part as
indicated in the drawing.
This operation is made easer since there is, in the inter-
nal part of the cover hinge lid a groove that facilates the
removal of this coomponent.
"Remove the part marked with DX, if the pivot pin is
inserted in the right hinge, SX in opposite case."
Apply covers (C-D) on joint cover lugs and into hinge
holes.Snap hinge covers (E) into position.
5. Separate parts Ha, Hb, Hc, Hd as shown in the figure.
6. Place guide (Ha) on the inside part of the furniture
door, up and down as shown in the figure and mark
the position of external holes. After having drilled
holes, fix the guide with the screws supplied.
7. Fix cover (Hc) on guide (Ha) until it clips into place.
8. Open the appliance door and the furniture door at 90°.
Insert the small square (Hb) into guide (Ha). Put togeth-
er the appliance door and the furniture door and mark
the holes as indicated in the figure.
GB
43